U盘写保护解决方法（国外英文资料）.doc

U盘写保护解决方法（国外英文资料） Methods/procedures one Classic solution 1: Check to see if the write protection switch on the top of the usb drive is turned on and the switch is the same as the floppy disk used in the past. Check to see if the number of files in the root directory of the usb stick is maximum, and the usual format should be 256. Right-click on the my computer - properties - hardware - device manager - universal serial bus controller, view The items in the project are all normal, and if there is an abnormal need to update the driver. The experiment found that the usb stick was replaced by another machine, indicating that the fault was not in the U disk itself, but on that machine. The formatting of the usb drive and the format of the conversion will not work. Solve the steps: 1) start -- runs -- regedit -- is determined to enter the registry. 2) see if there is any in HKEY_LOCAL_MACHINE \ SYSTEM \ ControlSet002 \ Control \ and HKEY_LOCAL_MACHINE \ SYSTEM \ ControlSet001 \ Control \ StorageDevicePolicies, and whether there is a WriteProtect value in the subitem, if any is changed to 0 and then to step 5; If not, take the next step. 3) check KEY_LOCAL_MACHINE \ SYSTEM \ CurrentControlSet \ Control \ StorageDevicePolicies such as the non-storagedevicepolicies, new (right-click on the Control point - , and rename the new item to StorageDevicePolicies) 4) the new Dword value in the right column, named WriteProtect, has a value of 0, 5. 2 Classic solution 2: Believe many people have met such a problem: good U disk, suddenly appear for the floppy disk is write protected and unable to write to a floppy disk, please write volumes of protection from drive \ DEVICE \ HARDDISK \ DR7. Unable to read data, not to write data. Finding a lot of times on the Internet that doesnt solve the problem? Then someone said, open the write protect switch (this is the most funny, I guess if I can find the switch, all tried, dont surf the Internet to find the answer) or your usb flash