广日电梯调试手册1（国外英文资料）.docVIP

广日电梯调试手册1（国外英文资料） Broad day elevator debugging manual Author: anonymous source: Internet hits: update time: October 29, 2007. First check the on-site electrical circuit. One. Maintenance test run A car repair: Check whether the setting parameters of the complex converter are in line with the requirements. In the car, the repair switch is put on the repair condition. Then, dont linger in the car, and operate on the computer room control panel. At this point the PC input point x7 bright, x10 extinguishing the mode of repair in the car. The internal instruction of the inside of the four car is available at the top of the 11l14 station and the input points are short. The inside of the car is available in the lower end of the car. B: at this time x7. X10 is not bright. It can be used for the test run. The roof of the car was overhauled to 11l40 and 21l6 short. 2. The top of the car was overhauled to a low 11l40 and 21l7. [x12]. Maintenance of elevator status; When the 11l40 is slow or slow down, the elevator should be closed immediately. After when the door is fully closed [y3 quenched; GMJ downward. Y14 or y15 ` y12 ` y0 light]. The elevator will start up or down immediately. Its time to see if the elevator is in the same direction as your instructions. If no, the set value of lf5 will be changed. Until the direction of the elevator is aligned with your direction. At the same time, observe the direction of the frequency converter parameter lf88 and lf89 [+ and -]. If not, the set value of lf18 will be changed. Until the same direction. Open the door immediately after the repair status is stopped. 5. Please note that due to the elevator first run, shaft is not clear, because the car collision on the shaft parts so ` downward trip dont control it too long. After the test and maintenance of the room is normal, the car can be operated on. The top of the car; Check to see if all switches in the safety circuit are valid. Check the top of the car for priority. After the above