车削切削用量的选择（国外英文资料）.docVIP

车削切削用量的选择（国外英文资料） The selection principle, method and main problem of CNC turning cutting and cutting China CNC information network Source: this site reads: 228 The amount of cutting in the CNC turning processing includes the backbite, the main spindle speed n or the cutting speed vc (for constant linear speed cutting), the feed speed vf or the quantity f. These parameters should be selected within the given scope of the machine tool. The selection principle of cutting dosage (1) the selection principle of cutting dosage In the case of a rough car, the high metal cutting rate and the necessary tool durability should be guaranteed. Selection, cutting dosage should be firstly selected as large as possible when turning the ap, secondly according to the machine power and rigid constraints, choose as far as possible big feeding f, according to the tool life requirements, determine appropriate cutting speed vc. Increasing the number of knives in the back can reduce the number of knives, and increase the quantity of feed f for cutting. The precision and surface roughness requirements are higher, and the processing allowance is not small and uniform. When choosing the amount of cutting of the fine car, it is important to consider how to ensure the quality of the processing and to improve the productivity. Therefore, refined car should choose smaller (but not too small) amount of turning and feeding, and selects the high performance of cutting tool materials and reasonable geometric parameters, to improve the cutting speed as much as possible. (2) the method of selecting the amount of cutting When the choice of the back of the knife is processed, remove all the residual amount of the knife as far as possible, except when the finishing allowance is left. You can also use the knife multiple times. The machining allowance is generally small and can be removed at a time. In the medium power machine, the rough back can be up to 8 ~ 10mm. 0.5 ~ 5mm for semi-finished backbite. The