链路聚合负载均衡冗余（国外英文资料）.docVIP

链路聚合负载均衡冗余（国外英文资料） Profile folding edit this section Link Aggregation (Link Aggregation), it is to point to to bundle multiple physical port together, become a logical port, in order to realize the/into the traffic load sharing in each members port, switches according to users configuration port load sharing strategy to decide which members of a message from the port sent to on the switches. When the switch detects one of the members of the port link failure occurs, stops on this port to send a message, and according to the load sharing strategy in the remaining link to recalculate the message sending port, fault port back again to recalculate the message send port. Link aggregation is an important technology in increasing link bandwidth, implementing link propagation flexibility and redundancy. If each link of the aggregation follows a different physical path, the aggregation link provides redundancy and fault tolerance. Link aggregation can be used to improve access to public networks by aggregating modem links or digital lines. Link aggregation can also be used for enterprise networks to build the backbone of the multigigabit network between gigabit Ethernet switches. Principle folding edit this paragraph The bandwidth of the logical link increases approximately (n - 1) times, where n is the number of paths for aggregation. In addition, the reliability is greatly improved after the aggregation, because as long as one of the n links is working properly, the link can work. In addition, link aggregation can achieve load balancing. Because, through the link aggregation together two (or more) of the switches (or other network devices), through the internal control, also can reasonably to data distribution, on the polymerization of connected devices for load sharing. Because communication loads are distributed across multiple links, the link aggregation is sometimes called load balancing. But load balancing ACTS as a data center technology that USES the technique to di