雕刻机在使用当中经常出现问题的解决方法（国外英文资料）.docVIP

雕刻机在使用当中经常出现问题的解决方法（国外英文资料） There are a lot of customer calls to ask some engraving machine in use often appear problem, we compiled a technical information about carving machine maintenance, for customers to maintenance reference: 1: it is not normal for the engraving machine to walk or walk on one or three shafts 1: control loose or malfunction. 2: the drive failure of the corresponding axis. 3: corresponding axial step motor failure. 4: the corresponding shaft is broken or loose. 5: the corresponding silk rod fault or the screw screw nut malfunction. 6: the corresponding axis of the shaft slips rapidly. 7: the drivers score, current, and software are different. Two: the engraving machine z is out of control 1: control loose or malfunction. 2: static electricity. 3: the z axis motor line failure 4: the file path is wrong 5: the frequency changer 6: computer systems have problems or viruses 7: error Three: error 1: control loose or malfunction 2: drive failure 3: step motor failure 4: static 5: motor line failure 6: data line failure 7: wrong path The shaft is broken or loose 9: processing too fast 0: computer system problem or virus The carving is very different 1: control loose or malfunction 2: step motor failure 3: driver failure or current segmentation is inconsistent with software setup 4. The z axis motor line failure Failure of spindle motor 6: the frequency converter interferes or sets the data incorrectly 7: static 8: computer virus or system problem Five: carving 1: control card failure 2: the frequency converter interferes 3: the file path is wrong 4: static 5: software setup has problems 6: driver failure or breakdown of current breakdown 7: data line failure 8: computers have virus or system problems 6: the engraving machine is uneven 1: the main shaft is not perpendicular to the table. Need to correct 2: the knife has a problem 3: the control card has a problem 7: the engraving machine cant go back to the mechanical origin 1: in the opposite directio