发一个通用的I-O模拟串口程序(适用于任何带有定时器的单片机).pdfVIP

电子下载站 资料版权归合法所有者所有 严禁用于商业用途 发一个通用的 I/O 模拟串口程序（适用于任何带有定时器的单片机） // UART.C // // Generic software uart written in C, requiring a timer set to 3 times // the baud rate, and two software read/write pins for the receive and // transmit functions. // // * Received characters are buffered // * putchar(), getchar(), kbhit() and flush_input_buffer() are available // * There is a facility for background processing while waiting for input // // Colin Gittins, Software Engineer, Halliburton Energy Services // // The baud rate can be configured by changing the BAUD_RATE macro as // follows: // // #define BAUD_RATE 19200.0 // // The function init_uart() must be called before any comms can take place // // Interface routines required: // 1. get_rx_pin_status() // Returns 0 or 1 dependent on whether the receive pin is high or low. // 2. set_tx_pin_high() // Sets the transmit pin to the high state. // 3. set_tx_pin_low() // Sets the transmit pin to the low state. // 4. idle() // Background functions to execute while waiting for input. // 5. timer_set( BAUD_RATE ) // Sets the timer to 3 times the baud rate. // 6. set_timer_interrupt( timer_isr ) // Enables the timer interrupt. // // Functions provided: // 1. void flush_input_buffer( void ) // Clears the contents of the input buffer. // 2. char kbhit( void ) // Tests whether an input character has been received. // 3. char getchar( void ) // Reads a character from the input buffer, waiting if necessary. // 4. void turn_rx_on( void ) 欢迎光临中国最大的电子工程师应用网站 网址： 电子下载站 资料版权归合法所有者所有 严禁用于商业用途 // Turns on the receive function. // 5. void turn_rx_off( void ) // Turns off the receive function. // 6. void putchar( char ) // Writes a character to the serial port. #include stdio.h #define BAUD_RATE 19200.0 #define IN_BUF_SIZE 256 #define TRUE 1 #define FALSE 0 static unsigned char inbuf[IN_BUF_SIZE]; static unsigned char qin = 0; static un