应急发电机试验册(正式).docVIP

Contents 目录 NO. Item Page Particulars of emergency generator 4 应急发电机参数 Test condition 4 试验条件 Test procedure 4 试验内容及程序 2.1 Alarm system and safety device test 4 柴油机的报警及安全保护装置试验 2.2 Starting test in cold state (oil and water to be check before test) 5 冷车启动试验 (在试验前检查油、水） 2.3 Loading test 5 负荷试验 2.4 Emergency D/G set governor and momentary characteristic test 6 应急发电机组调速器和瞬态调压特性试验 2.5 Voltage characteristic test 6 应急发电机稳态调压特性试验 2.6 Interlock function test 6 联锁功能试验 2.7 overload protection 7 过载保护试验 2.8 Fan and oil pump emergency stop 8 风油机应急切断 Attach :Test Report List 附：试验报告表 Particulars of emergency generator 应急发电机参数 Type 型号 UCM274F13 Rated Output 输出功率 125Kw Rated Voltage 电压 3φ　450V Rated Current 电流 200 Frequency 频率 60Hz Power factor 功率因数 0.8 (lagging) 0.8 (滞后) Insulation degree 绝缘等级 H Protection degree 防护等级 IP23 试验条件 Test condition 试验前应先完成下列项目。 Prior to this test. Followings to be completed 1.1 应急发电机机组、相关管系及油柜安装正确完整； Check the correctness of Emergency D/G and concerning pipe system installation 1.2 应急配电板的安装和接线验收合格； ESB installation and cable connection 1.3 报警及安全装置校验合格； Alarm system and safety device 1.4 应急配电板的绝缘电阻测量合格。 ESB insulation resistant 2．试验内容及程序 Test procedure 2.1 柴油机的报警及安全保护装置试验Alarm system and safety device test 下列报警装置应验证其功能：Validate the function of alarm devices as follows: item 名称 result 结果 set value 设定值 method 试验方法 alarm pos 报警位置 起动失败 Start fail Alarm shut-down 25SEC 见2.2.1 See 2.2.1 EG-S 滑油压力低 L.O. low press. Alarm 0.83bar 人为将滑油压力降低至报警值 Remove the L.O.Pres. to alarm value artificially EG-S 滑油温度高 L.O. temp high alarm 117 将温度探头拆下加温至报警 Remove the thermo sensor and h