低场优先与高场优先、基于帧有什么不同？(国外英文资料).docVIP

低场优先与高场优先、基于帧有什么不同？(国外英文资料) Whats the difference between a low field priority and a high-field priority, based on a frame? Each frame is divided into down, become line scanning video, because the TV set points and interlaced scanning line by line, generally televisions are interlaced. Now high-definition television is line-by-line, The partition is to show the part of the low field first, and then show the higher part of the field, Line by line is from above and below. General DV video acquisition are off (lower) priority, so that Chinese TV before if set to high starts, images will blink, basic frame is not breakout Why is there a play and the end A flashing light source, if the frequency reaches 50 times per second (that is, 50Hz frequency), he does not blink in the eyes of the person. The light bulb in our house was a light bulb, so we didnt see it in our eyes because it was 50Hz. According to this principle, the original set of images was set at 50 frames per second. It is thought that this image doesnt blink in our eyes. But according to the technology at the time, it was difficult to transfer 50 frames per second. This is based on how the picture tube works. The way the tube works is that the image is generated by firing electrons from the back of the picture tube, which hits the screen and creates a bright spot. If the resolution of the screen is 720 * 576, then the electronic gun starts at the upper left of the screen and moves over the right side of the screen through the control of the deflecting coil. To launch 720 electron, then move down to the bottom of the screen, after repeated 576 times by the strength of the emission electron to represent the pixel brightness, complete a frame of image transmission. You can figure that out. The electronic gun sends an image of 720 * 576 = 414720 electrons. If you were to transfer 50 frames per second, then he would be working at 414720 * 50= 2073600 / s. Gun cannot reach such a high frequency, the real reason is n