公共广播设计安装的小窍门(国外英文资料).doc

公共广播设计安装的小窍门(国外英文资料) Public broadcasting as a system, must be considered all kinds of factors that affect the design of the system. Therefore, should be based on the excellent performance of electroacoustic equipment selection, through careful system design, system debugging carefully and good acoustic conditions, in order to achieve a natural sound, electro acoustic. The following tips small finishing the design and installation of some public broadcasting system and emergency broadcast system, and everyone to share: Design tips for public broadcasting system: The transmission mode: output power feed mode system using cable radio transmission. The requirement of line attenuation in the public broadcasting system, from the farthest amplifier equipment output to the user on the line between the speaker line attenuation should meet the following requirements: Broadcast and business should not be greater than 2 dB (1kHz) - service broadcast should not exceed 1 dB (1kHz) Adopts the feeder lines of constant voltage output, the output voltage of 70V or 100V by. The calculation method of the capacity of power amplifier: The calculation method of business system and business radio broadcast system: P=K1 * K2 * Po Type: P-- power amplifier output total power (W); Po--Ki * Pi, each branch and radio (W) maximum power; The user equipment rated capacity of Pi-- I shunt; Ki-- I also need to shunt coefficient; Service broadcast program, each Ki 0.2-0.4 room; The background music program Ki 0.7-0.8 K1-- line attenuation compensation coefficient: line attenuation was obtained at 1dB 1.26; 2dB 1.58 line attenuation; K2-- aging coefficient, usually from 1.2-1.4; The fire accident and broadcasting system calculation method: the system calculation method has the following two ways: A. power amplifier capacity by 1.3 times the total number of the system to determine the speaker. 1.5 times the capacity of B. power amplifier according to the system of 3 layers of the total number of speak