城市热力管道施工(国外英文资料).docVIP

城市热力管道施工(国外英文资料) In the high school Construction of 2K315020 urban thermal pipeline Construction of 2k315020 urban thermal pipeline 2k315021 master urban thermal pipe construction requirements Engineering survey Line survey shall be consistent with: The main line, trunk line and branch line should be carried out. In the pipeline, fixed bracket, building on the ground, examination room, compensator, valves in the pipeline location, measure with ruler position method. Two 、 civil engineering The excavation of the earthwork must be provided with the trench side guardrail, the night light, the red light and other facilities according to the relevant provisions, and temporary roads and bridges shall be set up as required. Three, welding 2. butt joints with unequal wall thickness shall comply with the following provisions: (1) if the outer diameter is equal or the inner diameter is equal, the thickness of the piece is less than or equal to 4mm, and the thickness difference is greater than 3mm, and the thickness of the piece is greater than 4mm, and the thickness difference is greater than 30% or more than the thickness of the thin part, the thickness should be thinned. (2) when the diameter of the inner diameter and the outside diameter are unequal, and the thickness of the single side exceeds the value listed in the 1 paragraph of this article, the thickness of the pipe wall shall be thinned at one end, and the thickness at the interface after the thinning shall be uniform. 4. when welding below zero, the weldment should be preheated in the range of 50mm on both sides of the weld. 6. unqualified welding parts, should take measures to repair, the same part of the welding repair frequency shall not exceed 2 times. Four 、 piping installation and inspection 3. butt joint shall comply with the provisions 1. when docking the pipe mouth, the straightness of the pipe shall be checked and measured at 200mm from the interface center. The allowable deviation is LMM, and the maximum