田岛系列软件教程三(国外英文资料).docVIP

田岛系列软件教程三(国外英文资料) Three, a short tutorial on the islands software Three, a short tutorial on the islands software Author: the source of tujun: the post office teaching website: 2718 update time: 2004-9-2 Three, a short tutorial on the islands software Readers should note that in revision operations may encounter two cases, one is to directly modify directly to play in the computer version of embroidered pattern file (usually should be EMB format files), another kind of circumstance is to use embroidery disk DST file to redesign, which way is better? I think the EMB file format is ideal because the DST file is converted from EMB files or other format software. For fine flower, no matter what the operator use plate making software, more or less in the process of transformation will make DST file figure compared with the original a little deformation. Therefore, it is best to use EMB files to change the version of the EMB file. But sometimes meet customers directly provide embroidery disk to redesign, then it is best to use operation DG50 will redesign of flower-shaped read it out, and then save as EMB file format, and finally using DG60 will open this file, and then modify this way is the most ideal choice. 1, add and subtract the whole flower stitch number BR edit, the whole choice, the other to the processing, enter the target pin number, confirm 2, increase or decrease in the flower type stitch stitch count BR edit - select - according to stitch type - click the stitch to the other - processing - input pin number to determine the target 3, modify the size of the pattern, mirror (also called reverse), rotating the edit - all - object properties - general - enter the width and height dimensions or a percentage increase or decrease or in X axis mirror; Or the Y-axis, which is caught in the front frame; Or input rotation Angle to finish 4, change the embroidery sequence (1) according to color: edit - selection to modify, rearrange the order - by color - color