跳线的作用(国外英文资料).docVIP

跳线的作用(国外英文资料) Jumper is the little switch on the motherboard, (has) other boards, is used to manually, some software operation is not possible, such as manual to empty the BIOS, overclocking, etc. If the jump line on the motherboard is not correct, most of the time it may cause no indication of failure. In some cases, although it is shown, there are some problems, such as the failure of machine self-examination, the failure of the floppy drive, the instability of machine work. In rare cases, there may be no abnormal performance, but there is a serious risk that the day may result in damage to the motherboard, processor, or memory. Therefore, we must first jump the mainboard jump right according to the configuration of the machine. Operating points: (1) according to the type of processor, processor on operating voltage, frequency, frequency doubling, etc., the corresponding jumpers hopping right on the main board. (2) to see if there is an unknown jump line on the main board, if there is any, make sure that it is clear and correct. (3) if your memory is 168, it is important to know whether it is EDO or SD, since the two types of memory require different working voltages. Common failure triggered by motherboard wrong jumper and instance: a computer the basic five components after splicing, boot does not display, chassis speakers without the sound of the alarm. The computer USES the flagship 8STB motherboard, the CY233MX processor, 32MB SDRAM, S364V + graphics card. When you check the main board jump line, you find that the jumper that clears the CMOS content is in the state of clearing the CMOS, and changes it to NORMAL, and then returns to NORMAL. A lot of motherboards remove the jump line of the CMOS content if the jump fault is not shown. This jump line of a few motherboards will be displayed normally, even if it is wrong, but will prompt you to reset the CMOS parameter. Other may cause does not display the fault of the jump line error, common are: 1  the type of