LOFT隔层楼板搭建常识(国外英语资料).docVIP

LOFT隔层楼板搭建常识(国外英文资料) A prerequisite, build the attic 1, your house must have enough height. Generally speaking, the new floor floor penthouse room of the attic and the lower edge of the original layer of the lower edge is flat. The lower edge of the attic floor a monolayer of not less than 2.6 metres. In the attic floor and the roof height of not less than 2.4 meters, a minimum of not less than 2.2 meters. This is a personnel living as the premise, if you dont live in the attic, then you can decide the height. 2, the attic on both sides of the shortest span should not be too large. In the case of the use of steel structures, generally not more than 4 meters, the maximum shall not exceed 6 meters. 3, first of all have to refer to civil construction materials, see is to consider what type of the original architectural design How to set up the top floor of the attic floor To determine the function: the attic building, is sure to solve some practical problems, in order to meet the original pattern of the building can not meet the needs of function. Therefore, should first clear the future use of the attic, different functions have different requirements for space, which has a direct impact on determining the scope of the attic building and elevation. The determination of area: according to wall stress and load conditions can be roughly clear up the attic. There is no need to blindly blindly pursue area. Some of the higher floors, or double room with friends at the living room, maybe they will need to build a loft, and build the attic and involves some knowledge of the deep Type two, build the attic There are three kinds of ways, channel steel, steel, engineering cast-in-place reinforced concrete. The 1. channel is very cheap, easy to take, but poor sound effects. The work of the 2. most expensive steel sub process, trouble, but not out of the drawing and design institute. Summer heat, air conditioning room, easy to rust. About the price of 400-500. 3. cast-in-place rein