光电接近开关(国外英语资料).docVIP

光电接近开关(国外英文资料) Detection model of photoelectric sensor is divided into the following categories: shooting type and reflection type, polarization plate, straight trans, wide beam, focused, regional and regional adjustable type. Among them, the direct trans, wide beam, focused, regional and regional adjustable type is sometimes classified in the photoelectric proximity detection mode (Note: not with capacitive or inductive proximity switch confusion). The optical fiber sensor, such as the use of optical fiber, is the opposite type detection mode; such as the use of direct trans optical fiber for proximity detection mode. The ultrasonic sensor points of two kinds of mode detection type and close type. On the radio The transmitter and receiver type detection method of radio transmitter installation, light directly at the receiver. When the measured object from the beam when the sensor output changes to indicate the analyte to be detected. The opposite type is a kind of photoelectric detection mode of the earliest use of. Before the light modulation, at the transmitter and receiver is a big problem. Today, the photoelectric sensor using high modulation optical transmitter and receiver, the alignment has been very easy. Light path alignment of jet Optical alignment can make the maximum number of emitted light emitting light to reach the receiver, is located in the central location of the receiving area. When the transmitter is visible, as the optical alignment calibration is convenient, in front of the lens on the light receiver, to adjust the transmitter location through the observation on the spot according to the calibration. The calibration was removed, the excess gain observed on the sensor lights, one transmitter and receiver location in order to achieve the best alignment position. The detection distance of the radio - The detection distance sensor is a very important parameter. For the beam sensor, this parameter refers to the maximum distance between the transmit