桥梁施工工艺规范(国外英语资料).docVIP

桥梁施工工艺规范(国外英文资料) 1 scope of application This standard applies to the installation of plate rubber bearings, basin type rubber bearings and spherical bearings in road and urban bridge works. 2 construction preparation 2.1 materials 2.1.1 support: approach should have the packing list and certificate of product installation and support maintenance rules, regulations and the relevant technical specifications, quality and performance indicators in line with the current highway bridge support standard, and meet the design requirements. 2.1.2 preparation of epoxy resin mortar: two, butyl diamine, epoxy resin, xylene, fine sand, fine sand and other materials in addition to proper certification and instructions for use, fine sand varieties, quality should meet the relevant standards. 2.1.3 compounding concrete and compensating shrinkage mortar material. 2.1.3.1 cement: Portland cement and flexible Portland cement should be adopted. Approach should have product certification or testing report, deal with the strength, stability and other performance indicators after entering the necessary sampling reexamination, the quality must be consistent with current national standards Portland cement and ordinary portland cement GB175. When there is any doubt about the quality of the cement or the cement is out of production for more than three months, the re examination must be conducted before use and the result shall be used as a result of the retest. Different kinds of cement shall not be used in combination. 2.1.3.2 sand: sand varieties, quality should be consistent with current national standard technical specification for construction of highway bridges and culverts JTJ041, after entering the country in accordance with the provisions of the current standard test methods of aggregate for Highway Engineering JTJ058 sampling test. 2.1.3.3: we should use the hard stone or pebble gravel, and according to the origin, classification, processing methods and different specifications, acco