沙砾碎石(国外英语资料).docVIP

沙砾碎石(国外英文资料) Test questions of highway engineering test examiner (1) 1, site density detection method (A with sand filling method (B) and ring sampler (C), nuclear method (D), core drilling method (E), water bag method). 2. The method of determining the maximum dry density of subgrade soil is (A compaction method), (B surface vibrating compactor method), (C vibrating table method). 3, the determination method of the maximum dry density of asphalt mixture is (A Marshall test method), (B test road method), (C voidage reduction algorithm). 4, deflection test method (A Backman beam method), (B automatic deflection instrument method), (C drop deflectometer method). 5, Backman beam method is measured (A rebound deflection), automatic deflection instrument method is measured (B total deflection), drop hammer deflectometer is measured (C dynamic total deflection). 6, pavement deflectometer (A by Backman beam method (B), and the dial indicator) (C table). The ratio of the forearm length to the back arm length is (D2:1). 7, asphalt layer thickness is greater than (A5 cm) and the road temperature exceeds (B20 + 2 degrees) range, rebound deflection value should be temperature correction, the correction methods are (C mapping method) and (D empirical calculation method). 8, the determination of modulus of resilience test methods are (A direct method) and (B indirect method) two. The former are mainly (C bearing plate method), (D Backman beam method), the latter has (E CBR method), (F penetration meter method). 9, CBR (also known as A California bearing ratio), is used to assess subgrade soil and pavement material strength indicators, test methods (B indoor law), (C outdoor method), (D drop ball rapid determination method). 10, the skid resistance test methods are (A braking distance method), (B deflection wheel trailer method), (C pendulum pendulum method) and (D manual, electric sand laying method). 11, the thickness of the detection methods are destructive testing and non-dest