连接板课程设计(国外英语资料).docVIP

连接板课程设计(国外英文资料) 1 design title: connection plate production batch: mass material and thickness: 10, 1 mm The process of cutting the cutting parts of the cutting process is the design of the stamping process. Generally speaking, under the condition of meet the requirements of the use of artifacts, the easiest and most economical way to the workpiece coining out, said Ming stamping manufacturability of the good, otherwise, the parts manufacturability is poor. Of course, the quality of the process is relative, and it accepts the impact of the technical level and the equipment condition of the factory. The above requirements are the main factors to determine the structure, shape and size of the stamping parts. The part is analyzed according to this requirement. The cutting parts are simple, shape rules and geometric center symmetry. 3.1 geometry 3.2 the hole spacing, hole edge from the calculation of parts from the hole of 5.75 mm greater than the side holes of 1.5 t = x1 = 1.5 1.5 mm, pitch is 40 mm clear enough, so the parts is suitable for cutting. 3.3 punching minimal size look-up table 3 to 8 in reference [1]) (punching the minimum size of 1.3 t = 1.3 x1 = 1.3 less than ф 8.5, quick to rushed out of the hole. 3.4 the precision and roughness of blanking pieces Because the parts inside are not note the tolerance dimension, is a free size, can press IT14 level to determine the size of tolerance, as tolerance table each dimension tolerances are: 3.5 material 10 steel to carbon steel, check the attached (in reference [1]) shows its QuJiang is small, high elongation, stamping with good performance. Conclusion: this part for blanking 4 stamping process scheme is determined Determine the plan is to determine the process route of stamping parts, mainly including the number of stamping process, the combination of the process and sequence, etc. To determine the reasonable cutting process should be in a different process analysis to conduct a comprehensive analysis and resear