锡膏技术培训.pptVIP

* * * * 61 59 * * 62 60 * * 63 61 * * Mid chip balls are caused by placing a chip component with too much force onto too much solder paste. Paste squirts under the chip, is reflowed, melts into one large ball that pops out to one side. They have probably always been there but only became obvious with no-clean processes * * 65 63 * * “Home plate”designs and other modified shapes can be used to eliminate squirt-outs, either by removing paste from the danger area or by simply reducing the paste volume. For ICs and other land rows, ignore land size and make aperture width equal to half the pitch. The “standard 10-20% reduction” would print so much paste on wide lands that bridging would probably occur or make the aperture so narrow for narrow lands that paste would block in the apertures. * * 66 64 * * 69 67 * * 70 68 * * 67 65 * * 68 66 * * 71 69 * * 72 * * 73 70 * * 76 71 * * 77 72 * * 86 76 * * 87 77 * * CR32 优点 固体含量高 - 操作窗口宽 湿强度高 残留美观 可适用于封闭式印刷 抗吸潮性能出色 可适用于无铅合金 局限 开放寿命不长(网板寿命,印刷间隔时间,湿强度保持时间) 不能高速印刷 * * MP100 特性 高速印刷 开放寿命长 透明残留 残留物适用于探针测试 IPC LORO 级 25 - 200mm/s印刷速度 * * MP100 优点 固体含量高 -操作窗口宽 开放寿命长 抗热坍塌性能出色 可适用于封闭式印刷 高速印刷 适用于细间距元器件 局限 抗吸潮性有限 湿强度相对较低 不适用于无铅合金 * * 问题? * * 1 * * 2 * * 3 * * 4 * * 5 * * 6 * * 7 6 * * 8 * * * * 11 10 * * 12 11 * * 13 * * 18 * * 19 * * 28 34 * * 38 44 * * Comparing directly to squeegees..... The forces involved in screen printing are influenced by a number of interacting parameters, which effectively means we have very little control over the “critical” transfer forces. * * Comparing directly to squeegees..... The forces involved in screen printing are influenced by a number of interacting parameters, which effectively means we have very little control over the “critical” transfer forces. * * Comparing directly to squeegees..... The forces involved in screen printing are influenced by a number of interacting parameters, which effectively means we have very little control over the “critical” transfer forc