7-4-配置查看组播.pptVIP

* IGMP State in “rtr-a”: Group 224.1.1.1 is active on Ethernet 0 and Has been active on this interface for six days and 17 hours. It expires (and will be deleted) in two minutes and 31 seconds if an IGMP Host Membership report for this group is not heard in that time. The last Host to report membership was 1.1.1.11 (H2). Group 224.0.1.40 (Auto-RP) is automatically joined by Cisco routers and thus its expiration shows never. * Use the show multicast group command to display the multicast group configuration. Use the show multicast router command to display the information about dynamically learned and manually configured multicast router ports. IGMP keyword specifies to display only the configuration information learned through IGMP. 实施组播 配置及查看组播 嚏左桶邵雾停界斤筑悍粪蛾顽仙粱伯挠裹黄例松掳侣差尘醒甫胜堑羹敬废7-4-配置查看组播7-4-配置查看组播 PIM-SM配置命令 ip multicast-routing router(config)# 启用组播路由 ip pim { sparse-mode | sparse-dense-mode } router(config-if)# 在接口上启用PIM SM；选项sparse-dense-mode在该接口启用混合的稀疏-密集模式。 ip pim autorp listener 所有R ip pim send-rp-announce {interface type} scope {ttl} group-list {acl} 竞选RP ip pim send-rp-discovery {interface type} scope {ttl} 指定映射代理 router(config)# 配置AutoRP使之能够动态地选举并发布RP。 钨捻拿胖呛歧浮寄他江掠仗页卡非任狐莉夜间胃赠镊炎燥记姚钡胜湛滞静7-4-配置查看组播7-4-配置查看组播 查看组播路由表 显示IP组播路由表的内容 summary: 显示IP组播路由表中每个条目的简要信息 count: 显示每个组播组及其组播源的统计信息，包括报文数量、每秒报文数、平均报文大小以及每秒比特数等。 active: 显示当前活动的组播源发送数据到组播组的速率。活动组播源是指那些发送数据速率超过kbps的组播源。缺省kbps参数为4kbps。 show ip mroute [group-address] [summary] [count] [active kbps] router# 失梅鞘娜受镜叁柱绢睹吵瘸沾疙键渭义簧霖资剪味隧沁场之肌乘良荒广脆7-4-配置查看组播7-4-配置查看组播 show ip mroute NA-1#sh ip mroute IP Multicast Routing Table Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected L - Local, P - Pruned, R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT, M - MSDP created entry, X - Proxy Join Timer Running, A - Advertised via MSDP, U - URD, I - Received Source Spec