双阴山公路隧道设计土木本科学位论文.doc

本科学生毕业设计 双阴山公路隧道设计 系部名称： 土木与建筑工程学院 专业班级： 土木工程（岩土）10-2班 学生姓名： 齐　秀 指导教师： 夏岩昆　马桂军 职 称： 正高工　教 授 黑 龙 江 工 程 学 院 二○一四年六月 The Graduation Design for Bachelors Degree Design of the Shuangyin Hill Highway Tunnel Candidate：Qi Xiu Specialty：Civil Engineering（Geotechnical） Supervisors：Pro-Senior Engineer Xia Yankun Prof. Ma Guijun Heilongjiang Institute of Technology 2014-06·Harbin 摘　　要 本设计为双阴山公路隧道设计，该隧道位于伊春—鹤岗公路第三标段，为直线型分离式单向行驶两车道长隧道，上行线桩号为K20+163～K21+587，全长1424m；下行线桩号为K20+155～K21+600，全长1445m。所处围岩级别为III、IV级。隧道采用双向坡，坡度均为1%。隧道衬砌采用复合式衬砌，断面形式为曲墙拱形断面，洞门为翼墙式洞门，明洞与暗洞形式相同，明洞采用明挖法施工，暗洞采用新奥法施工。 本次设计主要内容为隧道总体设计、明洞设计、衬砌设计、通风照明设计、防排水设计、施工方案设计。通过总体设计确定了隧道平面、纵断面、横断面线形及人、车行横通道位置；通过洞门设计确定了洞门的位置及形式；通过明洞和衬砌设计确定了明洞长度、明洞及衬砌结构形式；最后确定了通风照明防排水及施工方案并绘制了27张图纸。 通过以上设计，经验算后，确定本次设计合理，方案可行。 关键词：隧道；衬砌；明洞；洞门；明挖法；新奥法 ABSTRACT This is the highway tunnel design of Shuangyin hill . The tunnel is located at the 3th section of the highway of Yichun to Hegang . It is a linear separated one-way tunnel with two lanes on eachside . The uplink is K20+163～K21+587 , and its total length is 1424m . The downlink mileage is K20+155～K21+600 , and its total length is 1445m .The strength of the surrounding rock of the tunnel belongs to III and IV level. This tunnel is designed as double slope, and the slope is 1% . The combined type is used linking . The cross section form of the tunnel is curved wall’s aches, and the tunnel portal is designed as the wing wall. Meanwhile, the open cut hole and the dark hole have the same form . The open excavation method is used to construct the open cut hole, and the dark hole was constructed by NATM . The main content of this design includes the overall tunnel design, the open cut hole design , the lining design , ventilation and lighting design , waterproof and drainage design, construction scheme design . According to the overall tunnel design determined the tunnel plane , vertical section and cr