如何使用LTT检测工具检独立式测磁带机-HPECommunity.docVIP

如何使用LTT 检测工具检测独立式磁带机 从HP 网站下载HP 检测工具 Library Tape Tools（LTT）， /cposupport/information_storage/support_doc/lpg50128.html ( 可以按照查找磁带机驱动程序的方法查找LTT，LTT 检测工具和每个产品的驱动程序放在一起) 安装LTT（选择默认参数） 启动，选择默认参数，进入，出现如下界面： 注意：如果系统中安装了备份软件，则启动LTT前，需要将备份软件的服务停止，否则由于备份软件对磁带机的控制权没有释放，LTT检测列出的磁带机硬件可能有红色差，如图： 选中需要检测的磁带设备，则磁带机的图片会显示，如图： 在图片的右侧可以看到磁带机的产品识别码（注意：不是产品产品型号）、Firmware 版本、SCSI ID 等信息， 选中设备，则点击图标“Test ”， 在窗口的右侧出现设备，打钩选中准备测试的设备，在Test Group 中有多种测试类型， 在“Description”中有每一种测试的说明，可以相应选择， 针对磁带机驱动器的测试共有6中， “Device Analyze”， This test performs analysis on your products internal data logs. If it finds problems it will give you advice on how best to solve them. “Connectivity Test”，This test writes data to the internal buffers in your product, to verify that the physical connection between your host and the storage device is operational. No data is written to a media, should there be one present in the drive. “Media Validation Test”， This test verifies the ability to READ data and check the integrity of the media in your storage device.  This test does NOT perform any writes to your media and will not affect its data contents in any way. “Read/Write Test”， 这种测试大约耗时 5 分钟This test verifies the ability to READ WRITE data to and from the removable media in your storage device. ** NOTE - This test is destructive and will overwrite data on the media that is present in your product when the test is started ** “Device Self Test”， This test performs a power on self test to check the internal electronics of your product. “Data Compression Test ”，这种测试大约耗时10分钟 This option will test the hardware compression capability of your tape drive. You will need a writable tape to complete this test. A file is created on tape that is designed to have a compression ratio of approximately 2:1, anything less than 2:1 could mean that your hardware compression is disabled. 通常，建议用户执行所有这六种测试，特别是Read/Write Test 和 Data Compression Test。 7、测试过程中有进程框可以显示测试进度，结束后会弹出一个窗口提示用户测试结果，用户也可以从Test Result 选项卡中直接