Fastenr_Torque_and_Fastening_(紧固件 扭矩问题).pptVIP

ABC about Fastener, Torque and Fastening on-site Issues 紧固件,扭矩和现场问题基础;Fastener Introduction;Fastener Introduction;Fastener Introduction;Fastener Introduction;Fastener Categories;Fastener Introduction;Fastener Introduction;Fastener Introduction;The head of bolt is marked with two numbers that indicate material properties used to define basic mechanical properties. 螺栓的头部标示了两个数字来表示定义基本机械特性的材料特性。 XX.Y;The bolt proof load,yield strength and minimum ultimate tensile strength in (KN) are derived by multiplying the corresponding stress (Mpa) values by the subject bolt stress area (mm^2). 螺栓的保证载荷，屈服拉力和最小极限抗拉强度（千牛）是通过将相应的应力值（兆帕） 乘以螺栓的承载面积。;The only nut property we will concerned with is proof load. Proof load of a nut is computed by multiplying the class marking stamped on the nut by 100, then multiplying by thread tensile stress area. 我们需要考虑到的唯一的螺母特性是保证载荷。螺母的保证载荷通过将印在螺母上的等级乘以100，然后再乘以螺母的同等受力面积得到的。;The Dynamics of Assembly;There are five different kinds of torque. 现在主要有五种种类不同的扭矩。; Breakaway Torque: The torque required to start an at rest fastener in the reverse tightening direction. 松脱扭矩：在一个紧固件被固定好之后，在紧固相反的方向上旋松该紧固件所需要的扭矩。 Prevailing Torque: A resistance to turn a fastener in the on or off direction, due to thread interference either intentional or unintentional. 锁紧扭矩：由于有意或无意的螺纹干涉，在紧固或松脱方向转动一个紧固件所需克服的抵制扭矩。 ;Properties of Dynamic and Static Torque ;Why do we choose dynamic torque as fastening standard? Reason 1: Dynamic torque best represents the torque developed during joint design activity from torque – tension, drive – strip and torque – angle testing. Reason 2: Dynamic torque depends upon the dynamic coefficient of friction for its value. This coefficient of friction tends to be more consistent and less variable than the static coefficient of friction. Reason 3: Dynamic torque also facilitates accurate torque measurement during the tightening of joints employing adhesive thread locking mec