螺栓预紧-内压-1pump-geom精要.docVIP

这个实例中要用到的cad模型文件和脚本文件都可以在 abaqus的sample文件夹（或者那个*.zip文件）里找到。 这个实例涉及到了用abaqus进行分析的整个流程中的各个细节，是入门的好帮手。像我这样的新手一定会喜欢的：） 部件：泵体+垫片+底盖+螺栓 荷载条件：螺栓预紧+内压 Introduction The structural response of the pump assembly shown in Figure W3–1 will be determined. The assembly components include the pump housing (imported as an orphan mesh), a gasket, a cover, and eight bolts (all imported as CAD geometry). The analysis involves application of pre-tensioning loads in the bolts followed by internal pressure. Figure W3–1. Pump assembly In this workshop, you will create the parts of the model. Use the Part module of ABAQUS/CAE to import the mesh of a pump housing. Some modifications of its geometric features follow. The other components of the pump assembly (cover, gasket, and bolts) will be imported as CAD geometry. All of the parts will be halved to take advantage of symmetry. Note: The parts created in this workshop will be used in subsequent workshops to build the complete model and to perform the analysis. It is important that you use the dimensions stated and not deviate from the workshop instructions; otherwise, you may find it difficult to complete the subsequent workshops. Orphan mesh import Follow the steps below to import the mesh of the pump housing model. 1. Start a new session of ABAQUS/CAE from workshops/pump directory. ABAQUS/CAE automatically loads the Part module. 2. From the main menu bar, select File?Import?Model. From the list of available models, select pump_ribs.inp. 3. ABAQUS/CAE takes a few seconds to import the model. Once the model is imported, you will be in the Assembly module. Switch back to the Part module. Notice that a new model (named pump_ribs) which contains the imported part (named PUMP–1) has been created. The model appears as shown in Figure W3–2. Figure W3–2. Orphan mesh of pump housing Editing nodal coordinates Your first task will be to change the inner diameter of the hole that goes through the top of the pump. The coordinates of the nodes