基于Perform-3D的型钢再生混凝土框架介绍.PDFVIP

第 47 卷 第 2 期 西安建筑科技大学学报（自然科学版） Vol. 47 No.2 2015 年 4 月 J.Xian Univ. of Arch. Tech. (Natural Science Edition) Apr. 2015  DOI ：10.15986/j.1006-7930.2015.02.006  基于 Perform-3D 的型钢再生混凝土框架 -填充墙结构力学性能分析 薛建阳，席 宇，高 亮 （西安建筑科技大学土木工程学院，陕西 西安 710055） 摘要 ：基于 3 榀缩尺比为 1:2.5 的单层单跨型钢再生混凝土框架-再生混凝土空心砌块填充墙结构在低周反复荷载作用下的试 验研究，采用有限元分析程序 Perform-3D 对该结构进行非线性分析，研究水平荷载作用下结构的出铰机制，轴压比、宽高 比对其承载力、刚度及延性的影响，并将计算结果与试验结果进行对比，两者较为符合．同时对试件承载力与顶点位移关系 F-D 曲线的影响因素进行分析，结果表明：随着轴压比的增大，框架的水平承载力及初始刚度有所提高，延性降低；随着宽 高比的增大，框架的水平承载力及初始刚度提高，但后期刚度退化加快，延性降低． 关键词：型钢再生混凝土框架；再生混凝土空心砌块填充墙；水平荷载；有限元分析；力学性能 中图分类号：TU398 文献标志码：A 文章编号：1006-7930(2015)02-0181-06 Analysis on the mechanical performance of steel reinforced recycled concrete frame-infilled wall structure based on Perform-3D XUE Jiangyang , XI Yu , GAO Liang (School of Civil Engineering, Xian Univ. of Arch. Tech., Xian 710055, China) Abstract ：Based on the experimental study of three 1/2.5-scaled model of one-bay and one-story steel reinforced recycled concrete frame-infilled wall with recycled concrete hollow block under low cyclic reversed loading ，the software Perform-3D was used for nonlinear finite element analysis on the frame to find out the subsequence of plastic hinges, the load-bearing capacity, the stiffness and the ductility was investigated under the horizontal loading considering the parameters such as the axial compression ratio, and the width-height ratio. The calculating results agreed well with the test results. The factors affecting the F-D curve were analyzed. The results show that with the increase of the axial compression ra