宋海峰参加《中国经营报》“富士康困局管理”沙龙关注员工心理健康.doc

宋海峰参加《中国经营报》“富士康困局管理”沙龙 关注员工心理健康 来源：2010.5.27 颐年康盛 2010年5月25日下午，应《中国经营报》社的邀请，宋海峰总裁与众多企业家、行业专家和相关人士代表出席了由《中国经营报》主办的“富士康困局管理”沙龙活动。 沙龙现场，众多嘉宾和专家针对当前的富士康员工连环跳楼事件及由此折射和反应出来的“代工模式”的发展、90后的管理难题（无处安放的青春)、企业“社会化”的边界等话题展开研讨，纷纷发言。宋海峰总裁就代工模式发展和员工心理健康发表了自己的观点和见解，得到了众多嘉宾的一致认可和高度认同。 本次沙龙中国经营报总编辑李佩钰，常务副总编王立鹏，副总编韩曦晨，编委汪静均出席参加。 沙龙现场一角 宋海峰总裁在现场（右一）宋海峰总裁就员工健康议题发言 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate