开关式电容器仪器构件的应用-ApplicationNote3July1985详解.PDFVIP

Application Note 3 July 1985 Applications for a Switched-Capacitor Instrumentation Building Block Jim Williams CMOS analog IC design is largely based on manipulation Conceptually, the LTC1043 is simple. Figure 1 details its of charge. Switches and capacitors are the elements used features. The oscillator, free-running at 200kHz, drives a to control and distribute the charge. Monolithic fi lters, data non-overlapping clock. Placing a capacitor from Pin 16 to converters and voltage converters rely on the excellent ground shifts the oscillator frequency downward to any characteristics of IC CMOS switches. Because of the im- desired point. The pin may also be driven from an external portance of switches in their circuits, CMOS designers have source, synchronizing the switches to external circuitry. developed techniques to minimize switch induced errors, A non-overlapping clock controls both DPDT switch sec- particularly those associated with stray capacitance and tions. The non-overlapping drive prevents simultaneous switch timing. Until now, these techniques have been used conduction in the series connected switch sections. only in the internal construction of monolithic devices. A ® Charge balancing circuitry cancels the effects of stray new device, the LTC 1043, makes these switches available capacitance. Pins 1 and 10 may be used as guard points for board-level use. Multi-pole