波前构建法中的网格点定位.pdfVIP

Applied Geophysics, Vol.6, No.3 (September 2009), P. 248 - 258, 10 Figures. DOI: 10.1007/s11770-009-0024-z Positioning of grid points in wave front construction* Han Fuxing1,2, Sun Jianguo1,2 , Sun Zhangqing1,2 , and Yang Hao3 Abstract: In view of the relative positioning problem between non-regular quadrilateral grids and regular rectangle grid nodes in the wave front construction method, concrete realization problems with four grid positioning methods (vector cross product judgment, angle sum, intersection-point, and signs comparison algorithms) in wave front construction which are commonly used in computer graphics are compared and analyzed in this paper. Based on the stability analysis of the location method, the calculation examples show that the vector cross product judgment method is faster and more accurate than other methods in the realization of the relative positioning between non-regular quadrilateral grids and regular rectangle grid nodes in wave front construction. It provides precise grid point attribute values for the next steps of migration and demigration. Keywords: wave front construction, grid localization, grid nodes, wave front quadrilateral Introduction Grid point positioning plays an important part in the realization of the wave front construction method (Han et al., 2007 and 2008). This is because the data obtained The wavefront construction method built by Vinje et by applying wave front construction ray tracing is non- al. (1993) is a fast and effective algorithm to calculate regular quadrangle grid data (the