- 1、本文档共14页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
porteus的快捷键和元件名(国外英文资料)
porteus的快捷键和元件名(国外英文资料)
TRAFFIC towns
7 seg - mpx2 - cc/ca
The BUTTON
LGM12641BS1R
F8: full display of the current workspace
F6: zoom in at the center of the mouse
F7: zoom out in the center of the mouse
G: grid switch grid grid
Ctrl + F1: the grid width 0.1 mm shows a grid of 0.1 mm, which is useful in PCB
F2: the grid is 0.5 mm with a grid of 0.5 mm, which is useful in PCB
F3: the grid is 1mm for 1mm and is useful for PCB
F4: grid 2.5 mm shows the grid 2.5 mm, which is useful in PCB
Ctrl + s: turn off the magnetosuction to be used for pointing at points, such as pins, etc
X: turn off the closed location coordinates to display a large cross ray
M: the unit switch between mm and th is shown in the lower right corner
O: reset the origin to the point where the mouse points to the origin
U: key revocation
Pgdn: change the layer
Pgup: change the layer
Ctrl + Pgdn: bottom
Ctrl + pgup: at the top
Ctrl + line: you can draw a curve
R: refresh
+ - : rotating
F5: relocation center
The Proteus element name is 1
Description of the name of the element
7407 driver gate
1N914 diode
74Ls00 and non-gate
74LS04 is not a door
74LS08 and the door
74LS390 TTL double decimal counter
7SEG 4 pin bcd-led output from 0-9 to the BCD code of the four lines
7SEG 3-8 decoder circuit bcd-7seg [size = + 0]
The ALTERNATOR ALTERNATOR
The AMMETER MILLI - mA AMMETER
AND gate
BATTERY BATTERY/BATTERY pack
BUS BUS
CAP capacity
CAPACITOR CAPACITOR
CLOCK signal source
CRYSTAL vibration
D - FLIPFLOP D flip-flop
FUSE FUSE
GROUND GROUND
LAMP LAMP
LED - RED light emitting diode
LM016L 2 lines 16 LCD display 2 lines 16 characters in English, there are 8 bits of data bus D0 - D7, RS, R/W, EN three control port (14), the voltage is 5 v. No backlight, and the commonly used 1602B function is the same as the foot (except for the two lines of the backlit).
The LOGIC ANALYSER logical analyzer
LOGICPROBE logic probe
The LOGICPROBE [BIG] logic probe is used to display the logical state of the connection position
LOGICST
文档评论(0)