叉车如何解体、清洗和检验(国外英文资料).docVIP

叉车如何解体、清洗和检验(国外英文资料) How does the forklift fall apart, clean and check How does the forklift collapse, wash and test 10-14 The collapse of the forklift truck Before the collapse of the forklift truck, it should be cleaned outside. Out cold water, and all parts (oil tank, the transmission, the main reducer, etc.) of lubricating oil, should comply with operation procedures and reasonable when the collapse of the order, and keep the job site clean and tidy. When disassembled, it often causes damage to parts, sometimes even to the extent that it cannot be repaired, so it cannot be taken lightly and carelessly. It must be understood that the quality and repair time of the forklift truck are directly affected by the dismemberment of the work. When disassembling, the repair and assembly shall be fully taken into account. The following points should be noted when disassembling: 1) it should be done in the order of decomposition first, first after the attachment. It can be decomposed by several assemblies, such as engine, hydraulic system, door frame hoisting system, clutch transmission, etc. 2) use the tools properly, instead of using pliers, wrenches, and screws for hammers and punch. To remove the pin, shaft, and liner of the static fit, apply the punch head or brass rod, not directly. Remove gear, belt wheel, and apply the pull device, such as no such tool can be used for soft metal shock, and the non-working surface is hit by symmetry. Remove the machine parts with adjusting gasket (steering gear adjusting gasket, main reducer adjusting gasket, differential adjusting gasket, etc.) not to damage the gasket. When it is difficult to disassemble the corrosion of organic parts, the oil and oil can be soaked and decomposed. Nut rusting when they cant split open out in addition to the oil immersion and heating, also can screw nut into 1/4 turn around first, then spin out, still can use the hammer to tap nut after four weeks, spin out again. When the bolt is broken inside the