内网FTP服务器架设指南(国外英文资料).docVIP

内网FTP服务器架设指南(国外英文资料) Since many people recently asked about how to set up FTP on the Intranet, heres a summary of the experience to share. This article is divided into four parts. The first section describes what is the problem of what is an internal network erection FTP. Part 2 analyzes the principles of the FTP protocol. The third part explains the problems and solutions that you will encounter when you set up an FTP server in your Intranet, enabling users of the external network to access the FTP server located in the Intranet. The fourth part is the summary. Readers are advised to read all of the five parts. If you only want a quick installation guide, read part one and part four. The FTP server used in this article is proftpd. The concept of an Intranet FTP server Conceive of such a environment: the following a few computer form a local area network (LAN), the LAN has a DHCP server is responsible for the IP address for each computer in the local area network (LAN) distribution. There is a computer (or network equipment) as a gateway () with the DHCP server for the same device, gateway connected to the Internet through a dial-up or other means, to get a real IP address. The computer in the LAN realizes the connection to the Internet through the forwarding of the gateway. We define the Intranet inside the Intranet, relative to the Internet, and define the Internet as an outer net. For example, suppose we have two computers, A, B, and A gateway G with dial-up and DHCP functionality. The respective network configurations are as follows: Gateway G: LAN IP address: (specified by the gateway hardware) LAN subnet mask: (specified by the gateway hardware) Wan IP address: 8 (acquired after dialing) A computer is A: LAN IP address: 0 (obtained by the DHCP function of the gateway) LAN subnet mask: (obtained by the DHCP function of the gateway) Gateway: (obtained by the DHCP function of the gateway) Computer B: LAN IP address: 1 (obtained by the DHCP function of the ga