家庭电工知识(国外英文资料).doc

家庭电工知识(国外英文资料) Household electrical Correct wiring for home use? The household wire should be used for the bv-70 polyvinyl chloride insulated copper wire or bvv-70 polyvinyl chloride insulated copper core wire, For regular mobile devices, such as the wiring board, the BVR -70 or BVVR -70 soft line should be chosen. How to change the three plug home appliances to two plugs? Many appliances are three plugs, but many of the homes electrical outlets are still single-phase two plug bases that need to be changed. Three of the three lines, one of which is the outer skin of the home appliance, should be pulled off from the outside, and the other two wires will be connected to the single plug. You must use a multimeter method to discern the line of the outer skin, not to connect the outer leather line to the zero line or the wire 3, the ordinary temperature control electric blanket is sometimes hot and sometimes not hot? Most of the electric blanket sold on the market today has only one temperature control switch, which can artificially adjust the heat Or low temperature. Because the switch is a double reed, frequent contact is not good. Together with the wire between the nickel-chromium metal and the copper wire, some use tin soldering, If the wire is a connection between the nickel-chromium metal and the copper, some of it is soldering, and if the two metals are unsoldered, it can also cause contact, Make the electricity hotline turn into electricity, turn off power, cause cold heat. In a series, the light indicates the status of the work, But in parallel, the difference is bad. When repairing, the switch should be taken apart, bending the reed, making the reed more elastic. If damaged, it should be replaced The reeds. The electric hot line and the copper wire are not welded, the small copper pipe that can be around 5mm, set on the joint of the two wires, with the pliers and the pliers, put on the outside of the copper pipe 15 mm - 20mm long plastic tube, heat and seal. H