建筑施工手册系列之构筑物工程 21-4 油罐(国外英文资料).docVIP

建筑施工手册系列之构筑物工程 21-4 油罐(国外英文资料) TXT is in a bad mood today. I only have four sentences to say. Including this and the preceding two sentences. My words are more wicked than he is to deal with the wicked. To deal with a despicable man is to be more despicable than he is, and to be in love with you, my lover. The cashier said: theres no change. Find you two plastic bags! This article was contributed by zi xian in 2006 Doc documents may have a poor browsing experience at the WAP end. It is recommended that you choose TXT, or download the source file to the native view. 21-4 tank The type and structure of the 21-4-1 tank The type and structure of the tank are shown in table 21-17. The type and structure of the tank A diagram types Table 21-17 Conditions of construction are applicable Brick wall tank For round or half underground type generally a few hundred tons Under type, its floor and roof, and to the thousands of tons of plane can be made into spherical shape or form, the small tank Its structure and brick wall pool is the same There are two kinds of common, is a kind of ring shaped column grid, beam plate flat top cover, by precast segment, circular arc beam, the center of circular plate and so on; Another is square or rectangular column grid roof cover. The wall thickness Commonly used 200 ~ 240 mm, base plate to P8 anti-seepage steel reinforced concrete, thickness of 200 mm tank top cover without girder and beam, and use, such as the thickness of the plate Direct bearing In a square of cloth on the column grid of column top put a big, cap formation, which as a support plate, can use cast-in-situ, can also be used for precast slab-column system Generally for big, small, medium tank, circular column grid beam plate flat top cover in the oil tank is widely applied in our country Beam flat top cover tank No girder roof tank The roof of the tank top is 5 ~ 6m, the payload is 5000N/m2, and the economy is covered with a flat roof with no girders Assembly ball top cover t