拨动开关的外部结构的焊接工艺(国外英文资料).docVIP

拨动开关的内部结构的焊接工艺(国外英文资料) The welding process of the internal structure of the toggle switch Internal resistance of the toggle switch in high temperature (above 70 degrees Celsius, for example) under the condition of affordable power will be significantly lower, such two resistor in parallel circuit effect will be better. Multiple resistance can be concluded that more ideal resistance through the combination of the resistance, such as 1.95 euro resistance than 2 the resistance in the actual application is more appropriate, if you want to buy a 1.95 euro resistance directly there is two 3.9 euro resistance is convenient, because 3.9 euro is the standard value, which is more than 1.95 euro. Jumper is used in the current loop, when after segmentation electrical ground plane, the shortest flow path fracture caused by signal. Toggle switch at this point, the signal circuits had to detour, form a large loop area, the influence of electric field and magnetic field is strong, easy to interference/be interference. By straddling the 0 o resistance in the partition area, you can provide shorter reflux paths and minimize interference. Configure the circuit generally, dont show the jump line and the dial switch on the product. In order to reduce the cost of maintenance, the application of 0 ohmic resistance is applied to the board. Vacant jump line at high frequency is equal to the antenna, good other purposes, with effect of SMD resistor load resistance R = 200 euro, so for the power supply can output 100 v, so the current can only 0.5 A, toggle switch for electronic circuits, the voltage is not directly as the power of the semiconductor device, also must pass A smooth processing (filtering). Smoothing is actually in the half-wave rectifier circuit output by one capacitor using dc motor power type of electrical equipment, such as the half-wave rectifier output voltage ripple is enough but when ac voltage is half cycle, the ac power through the diode to provide power to the load o