新时达F参数说明(国外英文资料).docVIP

新时达F参数说明(国外英文资料) Mainboard parameter specification (with no parameter classification operator) Parameter parameter meaning note the factory value unit read The acceleration of the slope adjustment is 550 mm/s2 0.55 m/s2 The slope of the deceleration is adjusted to the speed of the brake by 550 mm/s2 0.55 m/s2 The 2s curve T0 starts at the beginning of S curve at 1300 0.01 S 1.300 S The 3 S curve T1 is accelerating to the end of S curve at 1100 S 1.100 S The 4 S curve T2 decelerates at the beginning of S bend at 11000.01 S 1.100 S The S curve T3 deceleration S curve time 130.01 S 1.300 S The elevator rating of the elevator is 1750mm/s 1.75 m/s The rating of the motor rated speed motor is 1450rpm 1450rpm The pulse count of the encoder was 1024 PPR 1024ppr after the PPG The base station that is returned when the ladder is locked The solid layer is 0 The total number of plugboards installed in the total number of Wells is 18 The speed of service is 250 mm/s 0.250 m/s The speed of the return flat is 60 mm/s 0.060 m/s The door closes at 30 0.1 s The door will be open for 30 0.1 s The 16-gate delay is given by the governor running signal to begin the delay time of the opening and opening of the brake. 2 0.1 s, 0.2 s Removal of the running delay from the start of the lock to the removal of the governors signal from the delay time of 60.1 s 0.6 s Station 1 when fire station fire station fire status No.2 fire station 1 Delay return base time 0: no delay, return to base station immediately. 0 s 0 s The 21 flat layer error is the adjustment of the single layer of elevator and the flat layer error of the multi-layer operation The primary base station in parallel is the first base station in parallel (see F20, F196, F197) 1 In parallel mode 1: parallel ladder (compatible with old procedure) 2: group control (compatible with older programs) (see F181) 3 Driver mode 0: digital quantity; 1: analog 1 Type 1 X0 -x15, often open or close to 481 Type 2 x16-x31 input points often open o