星玛电梯DSS故障表(国外英文资料).docVIP

星玛电梯DSS故障表(国外英文资料) The TCD represents the text column Non Off Door SW The door machine switch cant OFF. - please check if the door machine is in common. -check the door and the door switch. 2 Non Off DCL The closing limit cannot be OFF. - please check the closing limit switch. 3 No Open feel The door machine wont open. - please confirm the status of the door limit and the closing limit. -check the door, please No Input Door SW Do not enter the door switch. -please check the door machine and the door switch. 5 No Input DCL Unable to enter the closing limit switch. - please check the closing limit switch 6 No Close feel The door machine cannot be closed. -check the door, please. 7 UL On UL in action. The -cap switch is not an action. -check the position or switch of the limit switch. 8 SUSL On SUSL had already moved before the top level slowed down. - please confirm the IPM5 setting time. - please adjust the location of USL or set time for IPM5. 9 USL ON USL in action. - please adjust the location of USL. 10 HUSL ON HUSL action. - adjust the HUSL position. 11 VHUSL ON VHUSL action. - please adjust the position of VHUSL. 12 MHUSL ON MHUSL action. - please adjust MHUSLs position. DL ON 13 DL action. -check the location or switch of DL. 14 high-bit-rate DSL ON SDSL was done before the minimum level of deceleration. - please confirm the timing of IPM4. - adjust the location of the DSL or the set time of the IPM4. 15 the DSL ON A DSL in action - adjust the location of the DSL. HDSL ON 16 HDSL action. -please adjust the location of the HDSL. 17 VHDSL ON VHDSL action. - adjust the location of the VHDSL. 18 MHDSL ON MHDSL action. -adjust the location of the MHDSL. 19 Overrun More than one layer runs the maximum time. - please confirm GPM1 time. 20 Overrun Level Cant start. 21 Over the Stop It stops after all levels are exceeded. -- on PPM, set the speed bump a little longer. 22 Small Over The Level is over. -- on PPM, set the speed bump a little longer. 23 Low Creep Speed It