机械设计技术要求大全(国外英文资料).doc

机械设计技术要求大全(国外英文资料) The weapons design technique requires the whole The 2007-04-25 14:45:03 medium Labelling: mechanical design technical requirement (today encountered a difficult problem, let me write a casting technical requirement, thanks to I also learn a little bit of mechanical design, in a search on the net, mechanical design and technical requirements, Shared here) The parts remove the oxidized skin. The surface of the parts shall not be scratched or scraped. Remove the burrs. Through the processing of adjustment, HRC50 ~ 55. 5. Parts for high frequency quenching, 350 ~ 370 ℃ tempering, HRC40 ~ 45. The carburizing depth of 0.3 mm. High temperature aging process. The non-shape tolerance should meet the requirement of GB1184-80. The unfilled length size allows the deviation to be plus or minus 0.5 mm. The casting tolerance band is symmetrical in the basic dimensions of the blank casting. No rounded radius R5. 12. Note chamfer are not 2 x 45 °. An acute Angle is blunt. Oil must be soaked before the sealing parts are assembled. 15. Assembly of hot charging rolling bearings allow used engine oil heating, oil temperature shall not exceed 100 ℃. After gear assembly, the contact spots and sides of the teeth should meet the requirements of GB10095 and GB11365. When assembling hydraulic systems, the sealing filler or sealant is permitted, but should be prevented from entering the system. All parts and parts (including foreign purchases and external components) of the assembly shall have the qualification of the inspection department to be assembled. The parts must be cleaned and cleaned before assembly, no burrs, flying edges, oxidized skin, rust, cuttings, grease, stain, dust etc. Before assembly, the main coordination dimensions of the components, especially the size of the full size and the relevant accuracy, are reviewed. The parts in the assembly are not allowed to knock, touch, scratch and rust. When fastening screws, bolts and nuts, it is strictly forbidden to