水温传感器激发的疑问弊病(国外英文资料).docVIP

水温传感器引发的疑难故障(国外英文资料) A Shanghai buick car, users reflect the vehicle starting difficulty, every time a starting three or four times the engine to the car, and the vehicle idle instability will occur after starting, hot water temperature is high, after the car exhaust smoke and throttle back easily flame-out phenomenon, at the same time the engine failure indicator sometimes normally on not extinguish. Inspect the car after coming to the factory and find that there is almost no sign of a car when it is not on the accelerator pedal. After stepping on the gas pedal, it is normal to start up, but the engine will not be able to lift the accelerator, and the engine will stall. But if youre stuck on the gas pedal after the car, youre going to slow down after a while On the accelerator pedal, the engine can run, but just step on the gas pedal and the engine is out of the fire. There was a slight improvement in the hot car, but it still happened. In fact, this type of failure occurs in other cars, mostly because of the serious damage caused by the dirty or idle control valves. And fault point lies mainly in air inflow is restricted, because cool car starting, the volume is relatively more, though the computer will control the idle speed control valve, but it requires a process. So a lot of time because of the throttle body dirty or idle speed control valve caused the car appear such serious fault formation, but the fault is rarely causes trouble light normally on not extinguish. After the hot car, the inspection also found that the electronic fans did not turn. But for the sake of safety, I first checked and cleaned the intake system. The results of the inspection are good for all piping connections in the air inlet system, no leakage, no plugging, and the throttle position sensor and idle control valve work well. Only the line of the car was confused, from the appearance of the fire, and the line of the idle control valve and the throttle position sensor was followed. In r