空调知识(国外英文资料).doc

空调知识(国外英文资料) Inspection and crew condition before mechanical operation (1) the installation is finished and inspected - before the test runs, all installations must be inspected. Inspection of machinery installation of the unit: check whether all the pipes and accessories have been installed; Check for the ease of the mechanical rotation: check the installation records at the same time. All projects that are related to the installation of centrifugal refrigeration units shall be completed, such as earth construction, water supply and drainage, electrical, instrument and heating, etc. Inspection of the foundations fastness and the integrity of the floor, and whether the trench cover is complete; Check whether the water pump is normal and the circulating water is in line with the requirements; Check the various gauges for which the debugging is used, whether they are normal and complete, and have no certificate of conformity and calibration tests. Check whether the circuit system has been tested, and whether the action is correct. Check for all safety measures: water supply and water line system installation, and ensure the passage of water. The fire equipment is ready; Winter test of temperature in the engine room should be more than 15 ℃, clean environment, the roads around the unit. If the unit leaves the factory for more than 6 months or the nitrogen in the machine has been leaking, it should be thoroughly dismantled. There must be a special person responsible for the dissection. Apply nitrogen to the assembly and then apply the oil to the friction area. (2) the state of the compressor, the state of the lubricating oil system, the electrical wiring and the state of the site, prior to the operation of the unit. The state of the compressor. The inlet of the compressor inlet is open and communicates with the atmosphere. The float chamber and the screen are removed and connected to the atmosphere. Take out the float valve parts and add cover to the throttle holes. The