理想GR1710故障代码详解(国外英文资料).doc

理想GR1710故障代码详解(国外英文资料) The ideal GR1710 failure code is detailed The serial number E01 Main motor lock Display and interrupt the machine running 2 seconds after the main motor overruns, the position A sensor can still detect the position of the roller (2) the position A sensor fails to detect cylinder position A within 5 seconds after the main motor starts E02 The elevator motors are locked Display and interrupt the machine running The action block of the upper and lower limit sensor is not lifted in the 9 seconds of the lifting motor starting up The action block of the lower and lower part of the sensor is not blocked in the 9 seconds after the lifting motor starts The action block of the lower and lower part of the sensor is not blocked in 2 seconds after the lifting motor starts up The action block of the lower and lower part of the sensor is still raised in two seconds E03 The first type of folder fault Show the interrupt machine running 1, the clip coil is activated in 4 seconds, and the action block that begins with the clip is still under pressure 2, the release of the clip coil is released (off) for 4 seconds, and the action block that begins with the security of the clip is still under pressure The Angle sensor (0 degree and 180 degree) is not detected in the Angle magnet in 8 seconds after the release When the coil is not made, the secure action block is not pressed E04 Ink overflow Display and interrupt the machine running The overflow sensor detects too much ink outside the extruding device E05 The printed position machine is locked In the printing position, the motor begins to rotate for 12 seconds, if the status of the sensor in the vertical center is not changed from pass to break or break to pass. E06 The pressure detection sensor failed Display and interrupt the machine running In 8 seconds after the main motor begins to rotate, if the pressure test sensor status is not switched or broken to pass. E07 (RA59 only) RA and RA edit board communication f