齿轮传动的设计计算(国外英文资料).docVIP

齿轮传动的设计计算(国外英文资料)Disp * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *.P1 = 22; N1 = 970; I = 3.5; K = 1.4;Hd = PI / 180; Ha = 1.0; Ca = 0.25;M = [2, 2.5, 3, 4, 5, 6, 8, 10, 12, 16, 20, 25, 32, 40, 50] The % first selects the first seriesDisp (note: the id of the type of gear and the hardness of the teeth below is capitalized and enclosed in single quotation marks)CL = input ( select gear materials: carbon steel - TG; alloy steel - HG = = );CM = input ( select tooth surface hardness class: hard tooth surface - YC; soft tooth surface - RC = = );The selection reference for the disp tooth width factor:The disp symmetrical arrangement - 0.8-1.4 soft teeth; Hard teeth 0.4 to 0.9 Dissymmetrical arrangement - 0.6-1.2. Hard teeth 0.3 to 0.6 The disp cantilever arrangement - the soft teeth 0.3 to 0.4; Hard-tooth surface 0.2-0.25 Fd = input ( select tooth width factor: Fd = );Disp = = = = = = = = = = = = = = = = = = = = = = = = = = =.Fprintf (1, active wheel transfer power P1 = % 3.3 f Kw \ n, P1)Fprintf (1, active wheel speed n1 = % 3.3 f r/min \ n, n1)Fprintf (1, the transmission ratio I = % 3.3 f \ n, I)Fprintf (1, load factor K = % 3.3 f \ n, K)Fprintf (1, the high tooth coefficient ha * = % 3.3 f \ n, ha)Fprintf (1, the gap coefficient c * = % 3.3 f \ n , Ca)Fprintf (1, the tooth width coefficient Fd = % 3.3 f \ n, Fd)Disp (note: the following input is the value of heat treatment hardness)If CL = = TGDisp gear material - carbon steelIf CM = = YCDisp sclerodac-stiff-teethHRC1 = input ( input pinion hardness HRC1 = );HRC2 = input ( big gear induction hardening hardness HRC2 = );CHM1 is 11 times HRC1 plus 610; CHM2 is equal to 11 times HRC2 plus 610.CFM1 = 380; CFM2 = 380;Elseif CM = = RCDisp tooth surface hardness - soft tooth surface HBS1 = input ( input pinion/HBS1 = );HBS2 = input ( large gear tuning/HBS2 = );CHM1 is (9 * HBS1 + 3750) / 10; CHM2 = (9 * HBS2 + 3750) / 10;CFM1 = (2 * HBS1 + 675) / 5; CFM2 = (2 * HBS2 + 675) / 5;The endElseif CL = = HG