PT100温度采集.doc

原理图设计 AD采集 转换显示 其他电路 程序设计 #includereg52.h #includeintrins.h #define uint unsigned int #define uchar unsigned char sbit led1=P1^0; //数码管位控制 sbit led2=P1^1; sbit led3=P1^2; sbit led4=P1^3; sbit sda=P3^4; //24C02数据端口 sbit scl=P3^3; //24C02时钟线 sbit beef=P3^5;//蜂鸣器驱动控制 sbit rd=P3^7; //A/D转换读信号 sbit wr=P3^6; //A/D转换写信号 sbit s1=P1^4; //按键 sbit s2=P1^5; sbit s3=P1^6; sbit s4=P1^7; uint num,temp,wendu,tiaojie,m; uchar qian,bai,shi,ge,moshi=0,moshi1=0,shangxian=70,xiaxian=20; uchar code table[]={0xA0,0xBB,0x62,0x2A,0x39,0x2C,0x24,0xBA, 0x20,0x28,0x30,0x25,0xE4,0x23,0x64,0x74};//数码管段码 void delay(uint xms) { uint i,j; for(i=xms;i0;i--) for(j=110;j0;j--); } /******************************************************** ====================24c02函数========================= *******************************************************/ void delay1(){;;} void start() //开始 { sda=1; delay1(); scl=1; delay1(); sda=0; delay1(); } void stop()//停止 { sda=0; delay1(); scl=1; delay1(); sda=1; delay1(); } void respons()//应答 { uchar i; scl=1; delay1(); while((sda==1)(i250))i++; scl=0; delay1(); } void init() //初始化 { sda=1; delay1(); scl=1; delay1(); } void write_byte(uchar date) //字节写 { uchar i,temp; temp=date; for(i=0;i8;i++) { temp=temp1; scl=0; delay1(); sda=CY; delay1(); scl=1; delay1(); } scl=0; delay1(); sda=1; delay1(); } uchar read_byte() //字节读 { uchar i,k; scl=0; delay1(); sda=1; delay1(); for(i=0;i8;i++) { scl=1; delay1(); k=(k1)|sda; scl=0; delay1(); } return k; } void write_add(uchar address,uchar date) //写入1字节 { start(); write_byte(0xa0); respons(); write_byte(address); respons(); write_byte(date); respons(); stop(); } uchar read_add(uchar address) //指定地址读 { uchar date; start(); write_byte(0xa0); respons(); write_byte(address); respons(); start(); write_byte(0xa1); respons(); date=read_byte(); stop(); return date; } void adstart() //启动