工程项目管流程完美修正版.doc

工程项目管理模 Gongcheng xiangmu guanli moshi 工程项目管理目 Gongcheng xiangmu guanli mubiao 工程质量目标 工期进度目标 成本控制目标 安全管理目标 文明施工目标 工程项目管理总流程 招标工作程序 监理工作程序 质量控制程序 工期控制程序 成本控制程序 重要材料控制程序 设计变更程序 隐蔽工程验收程序 竣工验收程序 合同管理程序 信息、资料管理程序 工程项目管理总流程 ( ( ( ( ( ( ( ((( ( 监理工作程序 总 监 理 工 程 师 建 立 项 目 监 理 部 编 制 项目监理部 监理规划 进驻施工现场 按 工 程 进 度 分 专 业 编 制 监 理 实 施 细 则 参加业主组织的设计技术交底会 参加业主主持召开的第一次工地会议 实 施 工 程 监 理 积累监理资料并及时整理、归档 组织工程预验收 并提出工程质量评估报告 参加竣工验收、交付使用 监理实施阶段工作总结 建立监理任务完成后 向业主提交工程监理档案资料 质量控制程序 质 量 控 制 工期控制程序 成本控制程序 重要材料控制程序 合同管理程序 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket wi