光纤交换机配置-命令模式.docxVIP

Zoning With CLI Commands Dell? PowerVault? 5xF Switches Zoning Guide ??Creating and Modifying Zone Aliases??Creating and Modifying Zones??Creating and Modifying Zone Configurations??Managing a Zone ConfigurationYou can zone Dell? PowerVault? switches using Command Line Interface (CLI) commands by creating and managing the three principal zoning object types—alias, zone, and configuration. You issue the commands during a Telnet session with the switch(es). (Refer to your PowerVault switch Installation and Troubleshooting Guide for details on creating a Telnet session with the switch.) NOTE: Before issuing any zoning commands, use the switchShow command on each switch in the zoned fabric to verify that all switches in the fabric are connected. All ports used for interswitch links (ISL) display the neighboring switches WWN and switch name. Follow this general sequence of steps when creating a new zone configuration.NOTE: See Zoning Roadmap in Introduction for additional guidelines on creating or managing zones. Define the core aliases. Define all zones. Add aliases and members to the zones. Define the zone configuration. Add zones to the configuration. Enable the configuration. Test the configuration. Save the configuration. Including Multiple Items in a CLI Command To include multiple items in a CLI command, separate the items with semicolons, within a single pair of quotes:command name_of_zoning_object, member; member; member For example, zoneAdd Red_zone, 1,10;1,12 adds domain 1, port 10 and domain 1, port 12 to zone Red_zone. Creating and Modifying Zone AliasesWhile aliases are not required in a zone configuration, they can make it easier to manage complex configurations in your zone. After you create aliases, you can then move to the next section and create and configure zones. aliCreateThe following example shows three instances of the aliCreate command, which creates a new zone alias.aliDeleteThe following example shows the aliDelete command, which deletes an ex