STD5732,105外层镀锌Y105颜色.docVIP

Electroplated coatings of zinc with chromating Y 105 Orientation As to its technical content, this standard conforms to ISO 4042 and SS 3191 for threaded parts and to ISO 2081 and SS 2968 for non-threaded parts. This standard does not apply to parts delivered to Volvo Car Corporation after 2005-07-31. For these parts, standard VCS 5737,19, VCS 5737,29 or VCS 5732,1059 applies within Volvo Car Corporation. This issue differs from issue 9 in that the term bright chromating has been changed to bright passivation and new text has been added under Orientation. The standard has also been given a new layout. The note: “The English language version is the original and the reference in case of dispute” has also been added. Contents 1 Scope 2 Definitions 3 Standardized coating thicknesses and designations 4 Application 5 Requirements 5.1 Appearance 5.2 Adhesion 5.3 Coating thickness 5.4 Corrosion resistance 5.5 Heat treatment - hydrogen embrittlement 5.6 Chromating 5.7 Hexavalent chromium content 6 Indication on drawing 1 Scope This standard covers electroplated coatings of zinc with chromating for protection of threaded and non-threaded parts of iron and steel against corrosion. 外层镀锌 Y105 颜色 目录 1范围 2定义 3镀层厚度标准及说明 4应用 5要求 5.1外观 5.2粘附 5.3镀层厚度 5.4抗腐性能 5.5热处理-氢脆 5.6染色 5.7六价铬含量 6在图纸中的标注 1范围 2 Definitions For the purpose of this standard, the following definitions apply. Significant surface: the part of the article covered or to be covered by the coating and for which the coating is essential for serviceability and/or appearance. If necessary, the significant surface shall be indicated on drawing and standard sample. See also STD 5730,21. Measuring area: the area of the significant surface over which a single measurement is made. Reference area: the area within which a specified number of single measurements is required to be made. See figure 1 for threaded parts. Local thickness: the mean of the thickness measurements, of which a specified number is made within a refe