中央电大历届钢结构试题库试卷代号1108(国外英语资料).docVIP

中央电大历届钢结构试题库试卷代号1108(国外英语资料) Test code : One One Zero 8 seat No. E Central Radio and Television University Two Zero One Two -2 Zero 13 semester of the first semester of the open undergraduate final exam Steel structure (Ben) examination questions January 2013 A number | I | two | three | four | score | | fraction I I, I, I, I, I Score | marking A single choice (the correct answer to each question number in parentheses, every day 2 points, a total of meter 30) 1. the design of steel structures in the ultimate state of bearing capacity shall be considered. The basic combination of A. load effects Standard combinations of B. load effects The basic combination of C. load effects is necessary, and the accidental combinations of load effects should be taken into account Frequency combination of D. load effects 2. in the structural design, the failure probability The relationship between PI and the reliable indicator Lu (). The greater the A. PI, the greater the size of the tower, the worse the structural reliability The bigger the B. PI, The smaller the {3, the worse the structural reliability The bigger the C., the smaller the PI, the more reliable the structure The bigger the D., the bigger the PI, the more reliable the structure 3. steel structure is more adaptable to dynamic load because of steel (). A. good plasticity, B., high strength and good plasticity C. good toughness, D. texture, homogeneous and isotropic 4., the effect on the fatigue strength of steel is not obvious (). A. stress amplitude; B. stress ratio C. steel grade D. stress cycle times 5., the friction type of high-strength bolts in the shaft direction of tension, the bearing capacity (). A. is related to the treatment of friction surfaces. B. is related to the number of friction surfaces C. is related to bolt diameter and D. is independent of bolt performance level 6. a suspender is arranged at the bottom of the steel beam, and the design value of the tension is 650kN (dead load) ) the boom passes th