土木工程材料复习资料(国外英语资料).docVIP

土木工程材料复习资料(国外英语资料) Wood engineering materials examination questions First, fill in the blanks (1 points per minute, totaling 20 points) 1., the hydrophilicity and hydrophobicity of the material are expressed by (wetting angle), and the moisture absorption of the material is expressed in terms of moisture content. The water absorbency of the material is expressed by water absorption. 2. when the plaster is hardened, the volume is (expanded) and the porosity is greater after hardening. 3. lime paste in the air hardening, is (crystallization) action and (carbonization) process at the same time to complete, so lime belongs to (air rigid) cementing material. 4. the molecular formula of the four mineral components in Portland cement clinker is (C3S), (C2S), (C3A) and (C4AF). 5. the reasonable sand rate of concrete is that the maximum fluidity of concrete can be obtained under the condition of (water consumption) and (cement dosage), and the sand content with good cohesiveness and water retention can be obtained. 6. the fluidity of masonry mortar is expressed in (sink), and the water retention is expressed by (delamination). In the design of 7. steel structure, the yield strength of carbon structural steel is taken as the basis for the design and calculation. 8, petroleum asphalt is divided into three parts according to (oil), (resin), (ground asphaltene). Two, determine the title (right in the stem in brackets marked tick, x is wrong. Every day 2,. A total of 16 points 1. the water absorption of the material is expressed by moisture content. (x) 2. rigid cementitious material that can harden in air and harden in water. (V) 3. in the mineral composition of Portland cement clinker, the fastest hydration rate is C3A. (V) 4., impermeability of concrete requirements, should not use slag Portland cement. (V) 5. the fluidity of concrete is expressed by degrees of immersion. (x) 6, the higher the relative humidity, the faster the carbonation of concrete. (x) 7. the greater the e