在AutoCAD轴测图的绘制方法(国外英语资料).docVIP

在AutoCAD轴测图的绘制方法(国外英语资料)Axonometric drawing is a two dimensional figure that reflects the three-dimensional shape of an object. It is full of three-dimensional feeling and can help people understand the product structure more quickly and clearly. Drawing a axonometric drawing of a part is done in the two-dimensional plane, and it is more convenient and convenient than the 3D figure.An entity of the axonometric projection only three visible plane, in order to facilitate the drawing, we will face the three as the benchmark plane painting line, find some other operations, and they are called the axis plane, according to the different position, called the left and right side of the axonometric axis surface and the top shaft measuring surface. When you activate the axonometric mode, you can switch between the three surfaces separately. The angle between a visible edge and a horizontal line in a axonometric drawing is 30 degrees, 90 degrees, and 120 degrees, respectively.Activate the axonometric projection mode1, method 1: tool sketch setting, capture and raster capture, industry and style: Isometric capture - sure, activate.2, at the command prompt, enter: snap style: S - axis measurement: I - Enter vertical spacing: 1 - activation complete.3, the axis of the switch method: F5 or CTRL E switch in turn, right, left three faces.Two. Draw a straight line in the axonometric projection mode1, the input coordinate point drawing:The line parallel to the X axis, the angle of the polar coordinates, should be entered at 30 degrees, such as @5030.The line parallel to the Y axis, the angle of the polar coordinates, should be entered at 150 degrees, such as @50150.The line parallel to the Z axis, the angle of the polar coordinates, should be entered at 90 degrees, such as @5090.All lines that are not parallel to the axis must first find the two points on the line and then connect them.2, you can also open the orthogonal state to draw lines. The following diagram can be drawn