主板检测卡代码对照表(国外英语资料).docVIP

主板检测卡代码对照表(国外英语资料) Check function Indicator function name lookup table lamp Chinese meaning CLK bus clock, regardless of ISA or PCI, as long as an empty board (no CPU, etc.) on the power supply, it should always light, or else CLK signal is bad. BIOS basic input and output, the motherboard running, reading operations on BIOS will flash. The IRDY main device is only ready to flash when it is ready to have IRDY signals, otherwise it is not lit. OSC oscillation, the main vibration signal of ISA slot, the power on the empty board should be always bright, otherwise stop vibration. FRAME frame cycle PCI slot, there is a circular frame signal, the lights are shining, usually light. RST reset, boot or press the RESET switch, bright half seconds to extinguish will be normal, if not destroyed, often because of the motherboard reset, pin connected to the acceleration switch or reset circuit is bad. The power board on the 12V power supply should be constantly bright, otherwise there is no voltage or the main board is short circuited. - 12V power board, power on board should be always bright, otherwise there is no voltage or the main board is short circuited. The power board on the 5V power supply should be constantly bright, otherwise there is no voltage or the main board is short circuited. - 5V power board, power on board should be always bright, otherwise there is no voltage or the main board is short circuited. (only the ISA slot has this voltage.) 3V3 power supply, this is PCI slot 3.3V voltage unique, empty board power should be always bright, and some have PCI slot motherboard itself without this voltage, it is not bright Motherboard check card code comparison table Look-up table must be read: 1, special code 00 and FF and other start code appear in three cases: After a series of other codes appear again: 00 or FF, then the motherboard ok. If no error is set in the CMOS, no serious fault will affect the continuation of the BIOS self check, and eventually there will be 00