电气接线标准.doc

WORK INSTRUCTION DKI GENERAL WIRING PRACTICES Scope This work instruction shall be applied in the Diamond Key International Workshops Electrical wiring on skids or associated is required. All wiring to be performed by qualified experienced wiring personnel using appropriate tools for stripping insulation, cutting, soldering and attaching mechanical crimp type terminals with the correct dies and tools as advised by the terminal manufacturer. Foremost electrical installations are to be performed to latest issue of wiring rules AS/NZS 3000 as well as IEC directives General installation: When removing insulation from the conductor, wire strands shall not be nicked or damaged. Proper stripping tools shall be used to avoid such damage. Wire and cable ties shall be snug but shall not be so tight as to cause indentation and cold flow damage to the insulation. Cable ties shall be tensioned and trimmed using cable tie manufacturers tooling. (Use of side cutters for trimming, is not permitted) All wiring within Exe, Exi or similar enclosures to be terminated. Where possible, adhesive installed mounting bases should not be used for ties or cable support unless affixed with a mechanical fastener. Wire and cable dress shall allow sufficient slack for removal and reapplication of the wire terminations, at least twice without excess tension. All wire and cable, including that in ducts and conduit, shall be handled to be free from kinks and insulation abrasions. Wire installation shall not be subject to accumulation of water, oil or other foreign matter. Instrument cables are to be free of Orange drain wires. Cable to be laid out neatly and undue crossing of cables is to be avoided (refer Appendix 3). All wire shall be protected against any contact with any surface other than that designed specifically to support or protect the wire. Protective edging, Grommets and similar materials shall be applied wherever any possibility exists for a wire to contact a sharp edge. A drip loop s