设计开模DFM样本.pptx

Ord No: M571 Mold No.: *** Part No.: 37-05385/ 37-05387 Part name: BASE PER EROGATORE VASCHETTA EROGATORE Date: 29-Jul,2016 index Mold basic information 1. Mold structure: 1.1 Parting line ; 1.2 Gate type/position; 1.3 Ejection type/position; 1.4 Mold layout ; 2. Part analysis: 2.1 Draft angle analysis (green without draft angle); 2.2 Thickness analysis; 3. Suggestion for part: Part data-37-05385 part name BASE PER EROGATORE part size (mm) L: 71mm W: 70.2mm H: 20.6mm weight (g) 10 gr surface finish Cavity: diamond polish Core: #320 sand paper material ABS SINKRALL C442 shrink. rate 0.55% Part data-37-05387 part name VASCHETTA EROGATORE part size (mm) L: 56mm W: 54mm H: 2mm weight (g) 39gr surface finish Cavity: #600 sand paper Core: #320 sand paper material ABS SINKRALL C442 shrink. rate 0.55% Mold data Mould No. GDM1654 Mold steel Cavity: 1.2083 HRC 50-52 Core : 1.2083 HRC 50-52 Slide : 1.2083 HRC 50-52 mold base: S50C Mold part standard Equivalent HASCO Number of Cavities 1+1 Gate type Cold runner+sub gate Ejection type Ejector pin Cooling by Water 1.11 Parting line Cavity PL Core 1.12 Parting line Cavity PL Core 1.13 Parting line- insert Cavity side(red line) Core side(red line) 1.14 Parting line- insert Core side(red line) Cavity side(red line) slide side(red line) slide slide 1.15 Parting line-slide 1.2 Gate – injection position Cold runner+sub gate Cold runner+sub gate 1.3 Ejection type position Ejector pin straight ejector block TOP 1.4 Mold layout slide slide 2.1 Draft angle analysis 2.11 Draft angle analysis 2.2 Thickness analysis 2.21 Thickness analysis 3.11 Suggestion for part No draft angle for green surface, suggest to add 1 degree by cut material, please confirm ! we will add 1degree draft angle. 3.12 Suggestion for part No draft angle for green surface, suggest to a